Solarmount

Solarmount

Mounting system for solar modules on vehicle roofs or boats. Solarmount allows you to set up in 4 directions. It also makes disassembly easier!

• NEW in version 2.0: the latching spring has been given an opening stop that also allows a small shackle lock to be attached. Note: you can still cut through the rubber + strap with a knife.
  Also: new design of the parts, larger adhesive surfaces, stronger screws, reduced lateral protrusion. (Pictures still version 1.0)
• Mounting system for solar modules on vehicle roofs, camping vehicles, touring vehicles, boats.
• The 4 movable corner fasteners allow an optimized alignment of the solar module to the sun and thus a considerable increase in efficiency: the projected area is enlarged and reflections are reduced.
• Can also be removed in a matter of seconds for installation further away from the vehicle or when not traveling
• Metal parts 2mm stainless steel, rubber joints EPDM with stainless steel custom-made! Durability: VERY long, there has not been a single complaint in 10 years.
• Installation angle depending on module dimensions 45-60°.
• Normal" version for module lengths up to approx. 1.5m (length of support bracket approx. 0.7m)
• Load capacity approx. 20kg. For larger modules, additional support of the longitudinal edges by means of rubber buffers is highly recommended.

Scope of delivery:

• 4x pre-assembled corner (triangular base section + rubber joint, angled module section with spring)
• 1 installation bracket M10 with rubber protection tube, pre-bent in the middle
• 1 center foot with ball pin + rope
• in bag:
• 16 screws M6x25, VA (hexagon socket or Torx, depending on availability)
• 16 self-locking flange nuts, VA
• 4 washers M10 large (usability depending on module frame)
• 2 hexagon bushes M10
• 4 M10x25 screws (hexagon socket or Torx)
• 2 igus rod ends M10 internal thread